Agilent Technologies ESA-E Series Programmer's Manual page 180

Set Center Frequency Step Size to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:STEP
Sets the center frequency step size to match the marker frequency. In
delta marker mode, the center frequency step size will be set to the
frequency difference between the markers. Select the delta marker
mode with :CALCulate:MARKer[1]|2|3|4:MODE DELTa. This
command is not available if the delta marker is off, or in zero span.
Front Panel
Access:
Marker –>, Mkr –> CF Step
Peak Search (or Search), Meas Tools, Mkr –> CF
Set Stop Frequency to the Marker Value
:CALCulate:MARKer[1]|2|3|4[:SET]:STOP
Sets the stop frequency to the value of the active marker frequency. In
delta marker mode, the stop frequency is set to the marker delta value.
This command is not available in zero span.
Front Panel
Access:
Marker –>, Mkr –> Stop
Marker On/Off
:CALCulate:MARKer[1]|2|3|4:STATe OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4:STATe?
Turns the selected marker on or off.
Front Panel
Access:
Marker, Off
Marker Table On/Off
:CALCulate:MARKer:TABLe:STATe OFF|ON|0|1
:CALCulate:MARKer:TABLe:STATe?
Turns the marker table on or off
Front Panel
Access:
Marker, Marker Table On Off
Marker to Trace
:CALCulate:MARKer[1]|2|3|4:TRACe <integer>
:CALCulate:MARKer[1]|2|3|4:TRACe?
Assigns the specified marker to the designated trace 1, 2, or 3.
Factory Preset
and *RST: 1
Chapter 5
Language Reference
CALCulate Subsystem
5-25