Load An Instrument State From A File; Load A Trace From A File To The Instrument - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference
MMEMory Subsystem
instrument. Loading a time limit line deletes any frequency limit lines.
Similarly, loading a frequency limit line deletes any time limit lines.
Example:
:MMEM:LOAD:LIM LLINE2,"C:mylimit.lim"
Remarks: There is no SCPI short form for parameters
LLINE1|LLINE2.
Front Panel
Access:
File, Load, Limits

Load an Instrument State from a File

:MMEMory:LOAD:STATe 1, <file_name>
The contents of the state file are loaded into the specified register. To
then load the register into the current instrument state use *RCL.
Example:
:MMEM:LOAD:STAT 1,"C:mystate.sta"
Remarks: See also commands :MMEMory:LOAD:STATe and
:MMEMory:STORe:STATe
If the revision of the state being loaded is newer than
the revision of the instrument, no state is recalled and
an error is reported.
If the revision of the state being loaded is equal to the
revision of the instrument, all regions of the state will
be loaded.
If the revision of the state being loaded is older than the
revision of the instrument, the instrument will only
load the older regions of the state.
Front Panel
Access:
File, Load, State

Load a Trace From a File to the Instrument

:MMEMory:LOAD:TRACe <file_name>
The contents of the file are loaded into TRACE1. The file name must
have a file extension of .trc or .csv. The file extension determines
whether a trace is loaded, or a trace with its state, are loaded. The .csv
extension is for trace files using the CSV (comma-separated values)
format. The .trc extension is for files that include both trace and state
data.
Example:
:MMEM:LOAD:TRAC "C:mytrace.trc"
Remarks: See also commands :MMEMory:LOAD:STATe and
:MMEMory:STORe:STATe
5-70 Chapter 5