3.3
Connect External Cables
Chapter 4. REAR PANEL CONNECTORS
Connect the cables to the proper locations on the rear panel.
3.4
Configuration and Operation
If you encounter any problems with installation or initial operation, make
sure to read Appendix A. SYSTEM CHECKOUT
for possible solutions.
Chapter 6. FAST ACTIVATION PROCEDURE
Chapter 7. FRONT PANEL OPERATION
Appendix A. TROUBLESHOOTING
Before attempting to operate your modem, make sure that:
•
You have made all the necessary cable, power, and ground connections.
•
You are operating with the latest available firmware load from Comtech EF Data.
•
You have installed all FAST Options or otherwise enabled all FAST features on your
modem. Refer to Chapter 6. FAST ACTIVATION PROCEDURE.
Do these steps:
1. Make to read and become familiar with Chapter 7. FRONT PANEL OPERATION before
proceeding.
2. Connect the supplied power cable between your power source and the SLM-5650A rear
panel.
3. Set the power switch to ON.
4. Do a check for the correct transmitter (Tx) and receiver (Rx) output signal levels and
spectrums.
5. Use the fronbt panel keypad and display to configure the modem.
Installation
The auto-sensing AC power supply does not require any adjustments.
TROUBLESHOOTING
AND
3–7
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A