Parts Identification - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.6 Parts identification

(1) MR-J3-100B-RJ080W or less
SW1 ON 4E
TEST
SW2
1
Fixed part
(2 places)
8
2
Name/Application
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Rotary axis setting switch (SW1)
SW1
Used to set the axis No. of servo amplifier.
8
Test operation select switch (SW2-1)
SW2
Used to perform the test operation
mode by using MR Configurator.
For manufacturer setting (Be sure to set
to the "Down" position).
1 2
USB communication connector (CN5)
Connect the personal computer.
Main circuit power supply connector (CNP1)
Connect the input power supply.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output.
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
option.
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis servo amplifier.
SSCNET cable connector (CN1B)
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
Direct drive motor power output connector (CNP3)
Connect the direct drive motor.
Encoder connector (CN2)
Used to connect the direct drive motor encoder.
Connector for manufacturer setting (CN2L)
Not used for this servo amplifier.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Battery holder
Install the battery MR-J3BAT.
Charge lamp
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal (
Ground terminal.
Rating plate
1 - 6
explanation
Refer to the
MR-J3- B
Instruction
Section 3.2
Section 3.3
Section 3.2
Refer to the
MR-J3- B
Instruction
Chapter 2
Section 3.2
Chapter 2
Section 3.4
Chapter 9
Refer to the
MR-J3- B
Instruction
)
Section 3.2
Section 1.4
Detailed
Servo
Amplifier
Manual.
Servo
Amplifier
Manual.
Servo
Amplifier
Manual.