Structure; Parts Identification - Mitsubishi Electric MR-J3-10B Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.7 Structure

1.7.1 Parts identification

(1) MR-J3-100B or less
www.DataSheet4U.com
Mounting hole
(4 places)
8
SW1 ON 4E
TES
SW2
1 2
Name/Application
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Rotary axis setting switch (SW1)
SW1
Used to set the axis No. of servo amplifier.
8
Test operation select switch (SW2-1)
SW2
Used to perform the test operation
mode by using MR Configurator (Setup
software).
Spare (Be sure to set to the "Down"
1
2 position).
Main circuit power supply connector (CNP1)
Connect the input power supply.
USB communication connector (CN5)
Connect with the personal computer.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
brake option.
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis servo amplifier.
SSCNET cable connector (CN1B)
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
Motor power supply connector (CNP3)
Connect the servo motor.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Battery holder
Contains the battery for absolute position data backup.
Protective earth (PE) terminal (
Ground terminal.
Name plate
1 - 8
Detailed
Explanation
Chapter 4
Section 3.13
Section 3.13
Section 3.1
Section 3.3
Section 11.5
Section 3.2
Section 3.4
Section 3.1
Section 3.3
Section 3.2
Section 3.4
Section 3.2
Section 3.4
Section 3.1
Section 3.3
Section 3.4
Section 11.1
Section 11.6
Chapter 12
Section 12.3
)
Section 3.1
Section 3.3
Section 1.5