Table of Contents
Advertisement
TIMING BELT
Timing Belt Installation Procedure
1.
Align timing mark on each sprocket with corresponding tim-
ing mark on the front case.
Timing mark
(on sprocket)
Timi~dO
(slot in front case)
Timing mark
(on front case)
2.
When timing belt "B" is installed, make certain that tension
side has no slack.
3.
Install tensioner "B" with center of pulley located on the left
side of mounting bolt and with pulley flange directed toward
front of engine.
4.
Align timing mark on the right counter balance shaft
sprocket with the timing mark on the front case.
5.
Lift tensioner "B" to tighten timing belt "B" so that its
tension side will be pulled tight. In this condition, tighten
bolt to secure ,tensioner "B". When bolt is tightened, use care
to prevent shaft from turning together. If shaft is turned
together, belt will be overtightened.
6.
Check to ensure that timing marks are in alignment.
7.
Check to ensure that when center of span on the tension
side is depressed with index finger in direction of arrow,
deflection of belt is within specification.
Belt deflection
5-7
mm
(0.2-0.3
in.)
20-30
Hide quick links:
Advertisement
Table of Contents
