Hyundai Sonata 1991 Shop Manual page 28

MAINTENANCE SERVICE
Recheck fluid level after transaxle is at normal operating
temperature.
9. Start engine and allow to idle for at least two minutes. Then,
with parking brake on,
move
selector lever momentarily to
each position., ending in "N" Neutral position.
10. Add sufficient ATF to bring fluid level to lower mark.
Recheck fluid level after transaxle is at normal operating
temperature.
Fluid level should be shown upper and lower marks of "HOT"
range. Insert dipstick fully to prevent dirt from entering
transaxle.
1. Check steering wheel freeplay.
Maximum steering wheel freeplay ..... 30 mm (1.181 in.)
2. Check steering linkage for looseness and damage as follows.
1) Tie rod ends do not have excessive play.
2) Dust seals and boots are not damaged.
3) Boot clamps are not loose.
INSPECT STEERING LINKAGE
POWER STEERING OIL PUMP BELT
(Check and service as required)
Y10£SOA
Yl0ETOA
1. Inspect the belt for evidence of cuts and cracks. Replace, if
necessary.
2. Check belt for proper tension. If necessary, adjust the belt
tension as follows.
1) Push the belt with a force of 98 N (22 Ib) at a point
halfway between the power steering oil pump pulley and
water pump pulley. The belt deflection should be 7 to 10
mm (0.28-0.39 in.)
2) If belt deflection is not within specified limits, loosen oil
pump mounting bolt, and
move
the oil pump to obtain
proper belt deflection at 98 N (22 Ib) force.
POWER STEERING FLUID LEVEL
(Inspect fluid level)
Y10EUOA
1. Park the vehicle on a flat, level surface, start the engine, and
then turn the steering wheel several times to raise the
temperature of the fluid to approximately 50°C (122°F).
2. With the vehicle still idling, turn the wheel all the way to
the left and right several times.
Check the fluid in the oil reservoir for foaming, check the
fluid level. and replenish the fluid in the oil reservoir through
the oil filter if necessary.
10-16