Table of Contents
Advertisement
GENERAL
3.
Using the special tool
(09431-21200),
tap the drive shaft
oil seal into the transaxle.
4.
Apply a coating of the transaxle oil to the lip of the oil seal.
09431-21200
REPLACEMENT OF SPEEDOMETER CABLE
v.,eLZA
1.
Remove the old cable.
2.
When connecting the cable to the speedometer, insert the
cable until its stopper properly fits to the meter side groove.
..
3.
Install the grommet so that. as shown in the illustration, the
cable attachment part and the projecting part are horizontal.
Caution
The cable arrangement should be made so that the radius
of cable bends is 150 mm (5.9 in.) or more.
4.
At the transaxle end of the speedometer cable, the key joint
should be inserted into the transaxle, and the nut should then
be securely tightened.
Caution
If the cable is not correctly and securely connected, it may
cause incorrect indication by the speedometer or abnor-
mal noise.
43-11
Hide quick links:
Advertisement
Table of Contents
