Table of Contents
Advertisement
GENERAL
Standard value : 4-8 mm (0.16-0.31 in.)
1. After warming up the engine, confirm that the accelerator
switch is on with the accelerator pedal in the free state.
3.
If the figured stroke B deviates from the standard value,
adjust it by the adjusting bolt.
Adjusting bolt
Y45C41A
NOTE
Check that the accelerator switch is on or off by checking
the voltage between the G wire and the ground wire at
the accelerator switch connector (2-pin).
When the accelerator switch is ON : 0 V
When the accelerator switch is OFF : 12 V
ACCELERATOR SWITCH CHECK AND
ADJUSTMENT
2.
Measure stroke B,
shown
in the
illustration of the
accelerator pedal. at the point when the accelerator switch
goes from ON to OFF when the pedal is depressed.
0--0: Continuity
O.5G(L)
~
O.5G (L)
O.5GR (E)
OFF (FREE)
ON (PUSH)
O.5GR(E)
Accelerator switch
IND.
LAMP
CRUISE ONLY
OVER DRIVE SW.
ACCELERATOR
sw.
L
E
ELC-4 ATM
CONTROL UNIT
IGN
sw.
r
T
J-
IGN
sw.
r
. ..L
l-
CRUISE EXCEPT
45-46
Hide quick links:
Advertisement
Table of Contents
