Table of Contents
Advertisement
AUTOMATIC TRANSAXLE ASSEMBLY
7)
Using a manual pump, pump air in from the position
shown in the illustration; then read the indication of the
dial gauge, and select the pressure plate that will provide
the standard value.
Standard value:
0.975-1.287
mm.
2.
Using the special tools
(09500-11000, 09532-11500),
tap
in the bearing outer race.
3.
Insert manual control shaft into transaxle case and push it
fully toward manual control lever.
At this time, do not install O-ring (larger one of two O-rings)
on manual control shaft.
NOTE
If installed before inserting shaft. the O-ring will interface
with shaft set screw hole.
4.
After installing new O-ring on manual control shaft, draw
shaft back into case, then install set screw and gasket. Also
install detent steel ball, seat and spring at the same time.
Set screw hole
Manual control
shaft
8-9.5 Nm
~Rt:~(6_7 fUbs.)
Manual control
shaft
Spring
45-75
Hide quick links:
Advertisement
Table of Contents
