Table of Contents
Advertisement
REMOVAL
IGNITION SYSTEM
Y27DlDA
1.
Disconnect the battery ground cable.
2.
Remove the two distributor cap retaining clips and move cap
to one side.
3.
Disconnect the lead wire connector.
4.
Remove the distributor mounting nut and remove the
distributor assembly.
1.
Lightly clamp the distributor in a vise equipped with soft
jaws.
2.
Pull off the rotor from the rotor shaft.
3.
Remove the packing rubber.
4.
Lift off the cover.
5.
Remove the rotor shaft by using a driver.
DISASSEMBLY
Y270MOA
7.
Remove the disc and spacer.
8.
Disconnect the lead wire connector.
9.
Lift off the plate and unit by removing the three mounting
screws.
10. Remove the shaft bearing tightening screws.
11. Make a position identification mark (for the drive gear) on
the distributor shaft.
12. Place the drive gear on a soft base (wooden block) so that
the over will not be damaged.
'
13. Drive out the roll pin by using a pin punch.
27-40
Drive gear
..L--Punch
Housing
Hide quick links:
Advertisement
Table of Contents
