Table of Contents
Advertisement
OIL PUMP ASSEMBLY
3. After immersing
driv~
and driven gears in automatic
transaxle fluid. install them to pump housing. When reusing'
gears. install with mating marks properly aligned.
4.
Fit a new O-ring into the groove at the inner circumference
'of the drive gear.
5.
Install, steel ball in hole as shown in the illustration.
6.
Install two seal rings coated with automatic transaxle fluid
to reaction shaft support.
7.
Make sure that oil pump gear turns freely.
8.
Install new O-ring in groove provided in circumference of
pump housing and apply petrolatum or industrial vaseline to
circumference of O-ring.
9.
Loosely install reaction shaft support on pump housing.
Tighten five bolts fingertight.
10.
With reaction shaft support properly positioned on pump
housing using special tools
(09452-21301. 09452-21401)
tighten five bolts to
10-12
Nm
(100-120
kg.cm.
7.5-8.5
Ib.ft).
45-98
~~x~~~~ 09452-21301
Hide quick links:
Advertisement
Table of Contents
