Table of Contents
Advertisement
AUTOMATIC TRANSAXLE ASSEMBLY
74.
Attach the end cover and fasten it with four bolts.
Caution
When installing the end cov!tr, be sure the screw hole is
correctly aligned. If the end cover is turned (after it is
installed) in order to align with the screw hole, the O-ring
and/or the O-ring may be twisted as a result.
75.
Install O-ring at center of top ot-valve body assembly (brake
oil pressure passage).
76. Install valve body assembly to case, fitting detent plate
(manual control shaft) pin in slot of manual valve.
77.
Replace the O-ring of the solenoid valve connector with a
new one.
78.
Insert the solenoid valve connector into the case. Be sure
that the notched part of tt)e connector faces as shown in the
figure.
79.
Tighten valve body assembly mounting bolts
(10
pieces) to
10-12
Nm
(100-120
kg.cm,
7.5-8.5
Ib.ft)
A :
18
mm
(0.709
in.) long
B :
25
mm
(0.984
in.) long
C : 40 mm
(1.575
in.) long
45-93
Hide quick links:
Advertisement
Table of Contents
