Table of Contents
Advertisement
COOLING SYSTEM
t
1.
Loosen the alternator support bolt "A", nut and alternator
brace bolt "B".
2.
Push the side of the alternator to relieve belt tension, a'nd
remove the belt.
3.
Remove the water pump pulley bolts and remove the water
pump pulley.
DRIVE BELT AND PULLEY
Removal
Y25DAOA
Inspection
Check following items and replace if defective.
1.
Check the surface for damage, peeling or cracks.
2.
Check the belt surface for oil or grease.
3.
Check the rubber for worn or hardened areas.
4.
Check the surface of the pulley for cracks or damage.
Installation
1. Install the water pump pulley to the water pump pulley
bracket and tighten the bolts firmly.
Tightening torque
Water pump pulley bolts
.
7.8-9.8
Nm
(80-100
kg.cm,
5.8-7.2
Ib.ft)
CAUTION
An overtensioned belt could cause not only premature
wear of the belt but will also damage the water pump and
alternator bearings.
2.
After installing the belt, adjust the belt tension.
25YOO9
25-9
Hide quick links:
Advertisement
Table of Contents
