Hyundai Sonata 1991 Shop Manual page 479

AUTOMATIC TRANSAXlE ASSEMBLY
58.
Check input shaft end play. Readjust if necessary (see step
51 ).
Standard value: 0.3-1.0 mm (0.012-0.040 in.)
59.
Apply solder [length approx.
10
mm
(0.40
in.) and diameter
3
mm
(0.118
in.)] to the differential assembly at the locations
shown in the illustration.
60.
Install new case gasket to transaxle case.
61.
Install converter housing and tightening
14 bolts to 19-23
Nm
(49O-2~0
kg.cm. 14-16 Ib.ft).
62.
Remove the converter housing and gasket.
63. Remove the crushed solder from outer race of differential
bearing.
64. Measure the thickness of the crushed solder micrometer and
select and install a spacer of thickness that gives standard
preload.
Standard value : 0.080-0.130 mm (0.003-0.005 in.)
45-90
Solder