Table of Contents
Advertisement
TRANSAXLE CONTROL
3.
When connecting the control cable to the uansaxle mounting
bracket, install the clip until it contacts the control cable, in
position switch in the figure.
4.
Install the cable mounting bolt.
5.
Install the air cleaner assembly.
6.
Install the nut, cable end pin, snap ring.
7.
Connect the position indicator light connector, the overdrive
switch connector, the parking position switch connector, and
the shift lock solenoid connector.
8.
Install the indicator panel, slider, indicator panel lower.
9.
Apply the specified grease at the places shown in the figure.
Specified grease: Multipurpose grease SAE J310 NLGI
No. 2
45-51
Hide quick links:
Advertisement
Table of Contents
