Table of Contents
Advertisement
DISASSEMBLY
CHARGING SYSTEM
Y27BGOA
1.
Remove the three through bolts.
2.
Insert a flat tip screwdriver between the front bracket and
stator core and pry downward.
CAUTION
1) Do not insert the screwdriver too deep, as this may
cause damage to the stator coil.
2)
The rear cover may be hard to remove because a ring
is used to lock the outer race of the rear bearing. To
facilitate removal of the rear cover, heat the bearing
section with a 200-watt soldering iron.
Do not use a heat gun, as it may damage the diode
assembly.
3.
Secure the rotor in a vise with the pulley side up.
21Y023
Bearing box
27Y024
CAUTION
Be careful that the vise jaws do not damage the rotor.
4.
Remove the pulley nut. spring washer and the pulley.
5.
Remove the front bracket and the two seals.
6.
Remove the rotor from the vise.
7.
Remove the brush holder screws, the rectifier screws, and
the nut from the B terminal.
8.
Remove the stator assembly from the rear bracket.
9.
Detach the slinger from the brush holder.
27-12
,
.
27Y025
Hide quick links:
Advertisement
Table of Contents
