Table of Contents
Advertisement
CLUTCH MASTER CYLINDER
Limit :
0.15
mm
(0.006
in.)
1.
Check the inside of cylinder body for rust or scars.
2.
Check the piston cup for wear or deformation.
3.
Check the piston for rust or scars.
4.
Measure the master cylinder inside diameter and the piston
outside diameter with a cylinder gauge and a micrometer.
NOTE
Measure the inside diameter of the master cylinder at
three places (bottom. middle, and top), each in two perpen-
dicular directions.
5.
If the master cylinder-to-piston clearance exceeds the limit,
replace the master cylinder and/or piston assembly.
Y41FBQA
INSPECTION
Specified fluid : DOT 3
1.
Apply the specified fluid to the inner surface of the master
cylinder body and to the entire periphery of the piston assem-
bly.
2.
Install the piston assembly.
REASSEMBLY
Y41FCOA
3.
Install the push rod.
NOTE: ADJUSTMENT OF THE PUSH ROD
1) Adjust the pedal height to the standard value by turning
the lock nut of the push rod.
2)
Adjust free play to the standard value on condition that
push rod is pulled to" .. direction and then lock the push
rod.
~ush
rod
41-16
Hide quick links:
Advertisement
Table of Contents
