Table of Contents
Advertisement
AUTOMATIC SPEED CONTROL (CRUISE)
2.
Pull cable tight in bracket with pulley against stop.
Tighten nut B against bracket.
Back nut B off 1-1/2 turn
3.
Tighten nut
A.
4.
Cable should have approximately 1.5 mm of slack with pulley
against stop.
r
Pulley housing stop
n..
....L
Intermediate
[
P}
J
pulley C stop
Actuator
~
cable
Cable adjustment stop location
1. Assemble the accelerator cable to the throttle valve pulley
(if not assembled.)
Attach the cable casing to the surge tank using the appro-
priate supplied adjusting bolts. Do not tighten the bolts at
this time.
2.
Insert a shim or similar tool, 1.5 mm thick, between the two
pulley stops (intermediate pulley B and C).
Final Cable Adjustment
Y27E2OA
1.5
mm
Actuator
cable
Intermediate
pulley 8 stop
Accelerator cable
3.
Adjust the cable casing at the rear side of the surge tank
to allow ALL the slack to be removed from the inner cable.
Make sure the throttle valve pulley remains in the "NOR-
MAL" idle position.
Tighten the adjustment bolts to the proper torque setting.
4.
Remove the shim from between the two intermediate pulleys
Band C.
CAUTION
Prior to proceeding with the final cable adjustments, make
sure that the pulley attached to the throttle valve is in the
"NORMAL" idle position.
AUTOMATIC SPEED CONTROL SWITCH INSPECTION
CHECKING AUTOMATIC SPEED CONTROL MAIN
SWITCH
Y27E30A
1. Turn the ignition switch to ON.
2.
When turning on the main switch, confirm that the indicator
lamp on the switch comes on.
Cable adjustment stop location
No SLACK
in accelerator cablel
Accelerator cable adjustment
27-69
Hide quick links:
Advertisement
Table of Contents
