Table of Contents
Advertisement
ENGINE AND TRANSAXLE ASSEMBLY
1. Remove the battery.
2. Detach the air cleaner.
3. Disconnect the connectors for the backup lamp and engine
harness.
ENGINE AND TRANSAXLE
ASSEMBLY
REMOVAL
Y20EAOA
4. Disconnect the connectors for the alternator harness, and
the oil pressure switch and oil pressure sender assy wiring.
5. Drain the engine coolant.
6. For vehicles with an automatic transaxle, disconnect the tran-
saxle oil cooler hoses.
NOTE
When disconnecting the hoses, make identification marks
to avoid making any mistakes in reconnecting them.
CAUTION
Be careful not to spill any of the oil or fluid out of the
hoses, plug the opening to prevent the entrance of foreign
material.
7. Disconnect the radiator upper and lower hoses on the engine
side, and then remove the radiator assembly.
8. Disconnect the high tension cable and all wires to the dis-
tributor from the ignition coil section.
9. Disconnect the engine ground.
10. Disconnect the brake booster vacuum hose.
11. Remove the fuel main, return and vapour hoses from the
engine side.
12. Disconnect the heater hoses (inlet and outlet) on the engine
side.
13. Disconnect the accelerator cable at the engine side.
14. For vehicles with a manual transaxle. separate the clutch hose
from the clutch tube.
15. For vehicles with an automatic transaxle, remove the control
cable from the transaxle.
20-23
Hide quick links:
Advertisement
Table of Contents
