Table of Contents
Advertisement
1.
Place selector lever in "N" (Neutral) position.
2.
Loosen control cable to manual control lever coupling
adjusting nut to set cable and lever free.
3.
Place manual control lever in "N" (Neutral) position.
INHIBITOR SWITCH AND CONTROL
CABLE ADJUSTMENT
GENERAL
Y45CZ1A
4.
Turn inhibitor switch body until 12 mm (0.47 in.) wide end
of manual control lever aligns with switch body flange [12
mm (0.47 in.) wide portion]. Or turn switch body until 5 mm
(0.20 in.) hole in manual control lever aligns with 5 mm (0.20
in.) hole in switch body.
5.
Tighten attaching bolts (2 pcs.) carefully so that switch body
is not displaced.
6.
Make sure that selector lever is in "N" (Neutral) position.
7.
Remove slackness of control cable by adjusting nut and then
check that selector lever moves smoothly.
8.
Check that control cable has been adjusted correctly.
12 mm(.47 in.)
Section A-A
45-41
Hide quick links:
Advertisement
Table of Contents
