Table of Contents
Advertisement
CLUTCH MASTER CYLINDER AND TUBE
2.
Temporarily tighten the flare nut by hand, and then tighten
it to the specified torque, being careful that the clutch hose
does not become twisted.
Secure side
3.
Install the clutch tube and clips.
4.
Install the master cylinder.
5.
Apply the specified grease to the clevis pin and washer.
Specified grease: Wheel bearing grease SAE J310,
NLGI No.2
6.
Install the push rod to the clutch pedal.
7.
Supply the clutch fluid.
8.
Bleed the Clutch tube (Refer to 41-9)
41-14
Hide quick links:
Advertisement
Table of Contents
