Hyundai Sonata 1991 Shop Manual page 29

POWER STEERING HOSES
(Check for deterioration or leaks)
MAINTENANCE SERVICE
Yl0EVQA
1. Check the hose connections for fluid leaks.
2. The power steering hoses should be replaced if there are
severe surface cracking. pulling. scuffing or worn steps.
Deterioration of the hoses could cause premature failure.
BALL JOINT AND STEERING LINKAGE SEALS,
STEERING AND DRIVE SHAFT BOOTS
Y10EWQA
1. These components, which are permanently lubricated at the
factory, do not require periodic lubrication. Damaged seals
and boots should be replaced to prevent leakage or
contamination of the grease.
2. Inspect the dust cover and boots for proper sealing leakage
and damage. Replace them if defective.
I
J
REAR WHEEL BEARINGS
(Inspect for grease leaks)
YlOEXOA
Inspect for evidence of grease leakage around the hub cap and
the back of the hub. If there is leakage of grease, remove the
hub and inspect its oil seal for damage. Clean the
grea~e
off the
hub and bearing and repack with specified new grease.
Specified grease :
Multipurpose grease
SAE
J310a, NLGI No.2
INSPECT BRAKE LINE
Y10EVOA
1. Check all brake pipes and hoses for damage. wear, cracks,
corrosion, leaks. bends, twists.
2. Check all clamps for tightness.
3. Check that the lines are clear of sharp edges. moving parts
and the exhaust system.
..
10-17