Table of Contents
Advertisement
CLUTCH COVER AND DISC
INSPECTION
CLUTCH COVER ASSEMBLY
Y41HBOA
1.
Check the diaphragm spring end for wear and uneven
height.
2.
Replace if wear is evident or height difference exceeds the
limit.
Limit: 0.5 mm (0.02 in.)
3.
Check the pressure plate surface for wear, cracks and color
change.
4.
Check the strap plate rivets for looseness and replace the
clutch cover assembly if loose.
Limit: 0.3 mm (0.012 in.)'
1.
Check the facing for loose rivets, uneven· contact. deteriora-
tion due to seizure, adhesion of oil or grease and replace the
clutch disc if defective.
2.
Measure the rivet sink and replace the clutch disc if it is out
of specification.
CLUTCH DISC
Y41HCOA
Rivet
sink
3.
Check for torsion spring play and damage and if defective,
replace the clutch disc.
4.
Combine the clutch disc with the inpu! shaft and check slid-
ing condition and check for play in the rotating direction. If
it does not slide smoothly, check after cleaning and reassem-
bling. If the play is excessive, replace the clutch disc and/or
the input shaft.
CLUTCH RELEASE BEARING
Y41HOOA
1.
The release bearing is packed with grease, so don't use clean-
ing oil, etc. to clean it.
2.
Check for bearing heat damage, other damage, abnormal
noise and/or improper rotation. Also check whether or not
there is wear at the point of contact with the diaphragm
spring.
3.
If there is abnormal wear at the point of contact with the
release fork, replace the bearing.
RELEASE FORK
Y41HEOA
1.
If there is abnormal wear at the point of contact with the
bearing, replace the release fork.
41-22
Hide quick links:
Advertisement
Table of Contents
