Table of Contents
Advertisement
STARTING SYSTEM
CAUTION
This test must be performed quickly (in less than 10
seconds) to prevent the coil from burning.
1.
Disconnect the field coil wire from the M-terminal of the
solenoid.
2.
Connect a 12V battery between the S-terminal and the
M-terminal.
3.
The pinion will move out.
SERVICE ADJUSTMENT PROCEDURES
PINION GAP ADJUSTMENT
Y27CCOA
12V
Field coil wire
27Y04O
4.
Check the pinion to stopper clearance (pinion gap) with a
feeler gauge.
Pinion gap :
0.5-2.0
mm
(0.02-0.079
in.)
Stopper
Pinion
27Y041
5.
If the pinion gap is out of specification, adjust by adding or
removing gaskets between the solenoid and the front
bracket.
27Y042
3.
If the pinion moves out, then the pull-in coil is good. If it
doesn't, replace the magnetic switch.
CAUTION
This test must be performed quickly (in less than 10
seconds) to prevent the coil from burning.
1.
Disconnect the field coil wire from the M-terminal of the
magnetic switch.
2.
Connect a 12V battery between the S-terminal and the
M-terminal.
27Y043
12V
'Field coil wire
Y27CDOA
MAGNETIC SWITCH PULL-IN TEST
27-23
Hide quick links:
Advertisement
Table of Contents
