Hyundai Sonata 1991 Shop Manual page 468

AUTOMATIC TRANSAXLE ASSEMBLY
18. Install snap ring on output flange rear bearing.
19. Coat petroleum jelly on the spacer and attach it to the
transaxle case.
20. Install two taper roller bearings and spacer to transfer idle
gear.
21. Place the transfer idler gear (assembled in the preceding
section) into the case, and then insert the idler shaft from
the outer side of the case and screw it in.
~
Torque converter side
Inner race
4---'ld::::-~=--- Outer race
Transfer idle gear
45-79