AUTOMATIC TRANSAXLE ASSEMBLY
5.
Install parking sprag rod to detent plate (manual control
shaft).
Install sprag rod support and tighten two bolts.
Sprag rod support bolts:
20-27 Nm (200-270 kg.em, 15-19 Ib.ft)
6.
Press-fit the bearing inner race to the transfer driven gear,
and press-fit the bearing outer race to the transaxle end
clutch side.
09432-21601
Transfer driven gear
7.
Press-fit the bearing inner race to the transfer shaft, and
press-fit the bearing outer race to the transaxle case
converter housing side.
09432-21601
Transfer shaft
8.
Attach the transfer shaft to the transaxle case.
45-76