Setting Up Forming Shields; Setting Up Forming Shields For Finger Conditioner - MacDon R113 Assembly Instruction Manual

6.4 Setting up Forming Shields

Each type of conditioner uses a different configuration for the swath forming shield. Refer to the applicable instruction for
the conditioner supplied with the machine.
If a finger conditioner is installed, refer to
If a roll conditioner is installed, refer to
If no conditioner is installed, refer to

6.4.1 Setting up Forming Shields for Finger Conditioner

On a machine equipped with a finger conditioner, the shields provide an enclosure for the fingers to flail the crop and
control distribution onto the field.
NOTE:
Transport not shown in illustrations for clarity.
1. Before setting up the forming shields, convert the header
to field mode. For instructions, refer to
from Transport to Field Mode – with Transport, page
2. Remove shipping wires (A) securing forming shield
covers (B) to pallet.
3. Support shield (C), remove two bolts at
locations (A) and (B), and remove the shield.
215585
COMPLETING ROTARY DISC PULL-TYPE ASSEMBLY
6.4.1 Setting up Forming Shields for Finger Conditioner, page
6.4.2 Setting up Forming Shields for Roll Conditioner, page
6.6 Discharge Shield – No Conditioner, page
9.2.2 Converting
175.
115
123.
Figure 6.13: Forming Shields Strapped to Pallet
Figure 6.14: Outboard Top Cover
115.
120.
Revision A