Route Map - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Sequence ID
IP Network Address
GE
LE
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to modify the specified entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Route Map

This window is used to view and configure the route map's settings.
To view the following window, click L3 Features > IP Route Filter > Route Map, as shown below:
The fields that can be configured are described below:
Parameter
Route Map Name
Direction
Sequence ID
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to modify the specified entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Description
Enter the sequence ID for this rule here. The range is from 1 to 65535.
Enter the starting and ending IPv4 addresses in the range used here.
Enter the minimum prefix length of the route that can be matched here.
The range is from 1 to 32.
Enter the maximum prefix length of the route that can be matched
here. The range is from 1 to 32.
Figure 6-187 Route Map Window
Description
Enter the route map's name here. This name can be up to 16
characters long.
Select the direction for this rule here. Options to choose from are
Permit and Deny.
•
Permit: Specifies that routes that match the rule entry are
permitted.
•
Deny: Specifies that routes that match the rule entry are denied.
Enter the sequence ID for this rule here. The range is from 1 to 65535.
310