D-Link DXS-3600 Series Reference Manual page 455

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The dynamic fields that can be configured are described below:
Parameter
Fragments
Source IP Address
Destination IP Address
Source MAC Address
Destination MAC Address
IP Precedence
ToS
DSCP
VID
Inner VID
CoS
Inner CoS
Description
Select the Fragments option to include packet fragment filtering.
Select and enter the source information here. Options to choose from
are Any, Host, IP, and Wildcard. When the Any option is selected,
any source traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the source host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, IP, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IP address here. When the IP option is selected, the
Wildcard option will also be available. Enter the group of destination
IP addresses by using a wildcard bitmap. The bit corresponding to the
bit value 1 will be ignored. The bit corresponding to the bit value 0 will
be checked.
Select and enter the source information here. Options to choose from
are Any, Host, MAC, and Wildcard. When the Any option is selected,
any source traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the source host's MAC
address here. When the MAC option is selected, the Wildcard option
will also be available. Enter the source MAC address and wildcard
value in the spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, MAC, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's MAC address here. When the MAC option is
selected, the Wildcard option will also be available. Enter the
destination MAC address and wildcard value in the spaces provided.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the outer VLAN ID that will be associated with this ACL rule
here. This value must be between 1 and 4094.
Enter the inner VLAN ID that will be associated with this ACL rule here.
This value must be between 1 and 4094.
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Select the inner Class of Service (CoS) value here. Options to choose
from are from 0 to 7.
444