Link Aggregation - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in Loopback Detection Global Settings are described below:
Parameter
Loopback Detection State
Mode
Enabled VLAN ID List
Interval
Trap State
Click the Apply button to accept the changes made.
The fields that can be configured in Loopback Detection Port Settings are described below:
Parameter
Unit
From Port ~ To Port
State
Click the Apply button to accept the changes made.

Link Aggregation

Understanding Port Trunk Groups
Port trunk groups are used to combine a number of ports together to make a single high-bandwidth data
pipeline. The switch supports up to 32 port trunk groups with up to 12 ports in each group.
Description
Select to enable or disable loopback detection. The default is
Disabled.
Select the loopback detection mode. Options to choose from are Port-
based and VLAN-based.
Enter the VLAN ID for loop detection. This only takes effect when the
VLAN-based is selected in the Mode drop-down list.
Enter the interval in seconds that the device will transmit all the CTP
(Configuration Test Protocol) packets to detect a loop-back event. The
valid range is from 1 to 32767 seconds. The default setting is 10
seconds.
Select to enable or disable the loopback detection trap state.
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select this option to enable or disable the state of the port.
131