D-Link DXS-3600 Series Reference Manual page 283

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in IPv6 Static Multicast Route Settings are described below:
Parameter
IPv6 Address/Prefix Length
Interface VLAN
RPF Neighbor Address
Click the Apply button to accept the changes made.
Click the Clear All button to clear all the IPv6 multicast static routes.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Multicast Routing Table
This window is used to display the contents of the IPv6 dynamic multicast routing table.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IPv6MC > IPv6
Multicast Routing Table, as shown below:
The fields that can be configured in IPv6 Multicast Routing Table are described below:
Parameter
Group IPv6 Address
Source IPv6 Address
Figure 6-141 IPv6 Static Multicast Route Settings Window
Description
Enter IPv6 network address and prefix length for the multicast source
here.
Enter the RPF VLAN interface's ID here. The range is from 1 to 4094.
The interface where the RPF neighbor IPv6 address is located is the
RPF interface.
Enter the IPv6 address of the next hop here that can be used to reach
the specified network. Selecting the NULL option specifies that the
RPF check result will always fail.
Figure 6-142 IPv6 Multicast Routing Table Window
Description
Enter the multicast group's IPv6 address here.
Enter the multicast source's IPv6 address here. Selecting the
Summary option specifies to display a one-line, abbreviated summary
272