D-Link DXS-3600 Series Reference Manual page 253

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in the table are described below:
Parameter
Neighbor Timeout
Probe
Metric
State
Click the Apply button to accept the changes made.
DVMRP Routing Table
This window is used to find and display DVMRP routing information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > DVMRP > DVMRP
Routing Table, as shown below:
The fields that can be configured in DVMRP Routing Table are described below:
Parameter
Source Network
Click the Find button to locate a specific entry based on the information entered.
Figure 6-99 DVMRP Interface Settings (Edit) Window
Description
Enter the neighbor's lifetime value here. If the router has not received
a probe message from a neighbor after the neighbor timeout interval,
the neighbor is supposed to be down. The range is from 1 to 65535
seconds. By default, this value is 35 seconds.
Enter the DVMRP probe interval value here. The range is from 1 to
65535 seconds. By default, this value is 10 seconds.
Enter the metric value here. The range is from 1 to 32. A value of 32
means infinity (unreachable). For each source network reported, a
route metric is associated with the route being reported. The metric is
the sum of the interface metrics between the router originating the
report and the source network. For DVMRP, the metric with 32 means
infinity (unreachable). This limits the breadth across the whole DVMRP
network and is necessary to place an upper bound on the convergence
time of the protocol.
Select to enable or disable the DVMRP feature on the selected
interface.
Figure 6-100 DVMRP Routing Table Window
Description
Enter the source IPv4 network address and mask length here.
242