Route Map Settings - D-Link DGS-3620-52P Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

Route Map Settings

This window is used to create a route map or add/delete sequences to a route map.
To view the following window, click L3 Features > IP Route Filter > Route Map Settings, as shown below:
The fields that can be configured are described below:
Parameter
Route Map Name
Click the Find button to locate a specific entry based on the information entered.
Click the Add button to add a new entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Delete All button to remove all the entries listed.
Click the View Detail link to view more information regarding the specific entry.
Click the Delete button to remove the specific entry.
Click the View Detail link to see the following window.
The fields that can be configured are described below:
Parameter
Sequence ID (1-
65535)
Direction
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Delete All button to remove all the entries listed.
Click the Edit button under Match Clause or Set Clause to configure the clause.
Click the Delete button to remove the specific entry.
Click the Edit button under Match Clause to see the following window.
Figure 5-14154 Route Map Settings window
Description
Enter the route map name.
Figure 5-1425 Route Map Settings - View Detail window
Description
Enter the sequence number for the rule.
Use the drop-down menu to Permit or Deny the matched rule.
255