Sflow Sampler Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
To view the following window, click Monitoring > sFlow > sFlow Receiver Settings, as shown below:
The fields that can be configured in sFlow Receiver Settings are described below:
Parameter
Receiver Index
Owner Name
Expire Time
Max Datagram Size
Collector Address
UDP Port
VRF Name
Click the Apply button to accept the changes made.
Click the Reset button to reset the specified entry's settings to the default settings.

sFlow Sampler Settings

This window is used to view and configure the sFlow sampler settings.
To view the following window, click Monitoring > sFlow > sFlow Sampler Settings, as shown below:
Figure 13-8 sFlow Receiver Settings Window
Description
Enter the index number of the receiver here. This number must be
between 1 and 4.
Enter the owner name of the receiver here. This name can be up to 32
characters long.
Enter the expiration time for the entry here. The parameters of the
entry will reset when the timer expired. The range is from 0 to 2000000
seconds. Selecting Infinite specifies that the entry will not expire.
Enter the maximum number of data bytes of a single sFlow datagram
here. The range is from 700 to 1400 bytes. By default, this value is
1400 bytes.
Enter the remote sFlow collector's IPv4 or IPv6 address here.
Enter the remote sFlow collector's UDP port number here. This
number must be between 1 and 65535. By default, this value is 6343.
Enter the VRF instance's name that will be used in this configuration
here. This name can be up to 12 characters long.
594