D-Link DXS-3600 Series Reference Manual page 276

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
PIM for IPv6 (S,G) Keepalive Time
This window is used to view and configure the IPv6 PIM (S,G) keep-alive time settings. This feature is
used to configure the keep-alive timer, which is the period during which the PIM router will maintain the (S,
G) state in the absence of explicit (S, G) local membership or (S, G) join messages received to maintain it.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 (S,G) Keepalive Time, as shown below:
The fields that can be configured in (S,G) Keepalive Time are described below:
Parameter
(S,G) Keepalive Time
Click the Apply button to accept the changes made.
PIM for IPv6 Mroute Table
This window is used to display all entries in the IPv6 multicast routing table. The switch populates the
multicast routing table by creating source, group (S,G) entries from star, group (*,G) entries. The star (*)
refers to all source addresses, the "S" refers to a single source address, and the "G" is the destination
multicast group address. In creating (S,G) entries, the software uses the best path to that destination
group found in the unicast routing table, through Reverse Path Forwarding (RPF).
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 Mroute Table, as shown below:
PIM for IPv6 Neighbor Table
This window is used to display IPv6 PIM neighbor information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 Neighbor Table, as shown below:
Figure 6-131 PIM for IPv6 (S,G) Keepalive Time Window
Description
Enter the (S,G) keep-alive time value here. This specifies the period
during which the PIM router will maintain the (S, G) state in the
absence of explicit (S, G) local membership or (S, G) join messages
received to maintain it. The range is from 120 to 65535 seconds.
Select the Default option to use the default value, which is 210
seconds.
Figure 6-132 PIM for IPv6 Mroute Table Window
265