Mpls Forwarding Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
SN
Action
IP Address
Mask
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear All button to clear all the entries.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MPLS Forwarding Settings

This window is used to view and configure the MPLS feature's forwarding settings.
The Static FTN Settings section is used to add or delete a static FEC-To-NHLFE Map (FTN) entry. FEC
stands form Forwarding Equivalence Class and NHLFE stands for Next Hop Label Forwarding Entry. At
the ingress Label Edge Router (LER), the incoming IP packets that are classified to the Forwarding
Equivalence Class (FEC) will be pushed with the MPLS label and forwarded to the next hop according to
the FEC-to-NHLFE (FTN).
The Static ILM Settings section is used to add a static Incoming Label Map (ILM) entry. At LSR, the
incoming MPLS packets that are matched to the incoming label will be processed according configured
ILM action. The label operation is either swapping the incoming top label to configured outgoing label or
popping the top label and then forwards the packets to the next-hop.
To view the following window, click MPLS > MPLS Forwarding Settings, as shown below:
Figure 11-2 MPLS LSP Trigger Information Window
Description
Enter the sequence number of the LSP trigger filter rule here. When
creating a new rule, if not specified, the SN begins from 10 and is
incremented by 10. The range is from 1 to 10000.
Select the action that will be taken here. Options to choose from are
Permit and Deny.
•
Permit: Specifies to permit LDP in establishing the LSP to follow
the IP prefix FEC.
•
Deny: Specifies no permit LDP in establishing the LSP to follow
the IP prefix FEC.
Enter the IPv4 address FEC on which the rule will apply.
Enter the subnet mask FEC on which the rule will apply. Selecting the
Any option specifies that the rule will apply on any IP prefix FEC.
567