Ethernet Oam Configuration Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Received Remote Loopback
Click the Apply button to accept the changes made.
The fields that can be configured in Ethernet OAM Table are described below:
Parameter
Unit
From Port ~ To Port
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.

Ethernet OAM Configuration Settings

This window is used to view and configure the Ethernet OAM feature's configuration settings.
To view the following window, click OAM > Ethernet OAM > Ethernet OAM Configuration Settings, as
shown below:
Description
remote loopback mode, administrators must ensure that the local client
is in the active mode and the OAM connection is established. If the
local client is already in the remote loopback mode, then this feature
cannot be applied.
Select to configure the behavior of the received remote loopback
requirement from the peer on the specified port(s) here. Options to
choose from are Ignore and Process.
•
Ignore: Specifies not to react to remote loopback requirements
from a peer.
•
Process: Specifies to react to remote loopback requirements
from a peer.
The feature is used to configure the client to process or to ignore the
received Ethernet OAM remote loopback feature. In the remote
loopback mode, all user traffic will not be processed. Ignoring the
received remote loopback feature will prevent the port from entering
the remote loopback mode.
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
553