D-Link DXS-3600 Series Reference Manual page 505

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in ARP Inspection Validation are described below:
Parameter
Src-MAC
Dst-MAC
IP
Click the Apply button to accept the changes made.
The fields that can be configured in ARP Inspection Filter are described below:
Parameter
ARP Access List Name
VID List
Static ACL
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove an entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Figure 9-44 ARP Inspection Settings Window
Description
Select to enable of disable the source MAC option here. This option
specifies to check for ARP requests and response packets and the
consistency of the source MAC address in the Ethernet header against
the sender MAC address in the ARP payload.
Select to enable of disable the destination MAC option here. This
option specifies to check for ARP response packets and the
consistency of the destination MAC address in the Ethernet header
against the target MAC address in the ARP payload.
Select to enable of disable the IP option here. This option specifies to
check the ARP body for invalid and unexpected IP addresses. It also
specifies to check the validity of IP address in the ARP payload. The
sender IP in both the ARP request and response and target IP in the
ARP response are validated. Packets destined for the IP addresses
0.0.0.0, 255.255.255.255, and all IP multicast addresses are dropped.
Sender IP addresses are checked in all ARP requests and responses,
and target IP addresses are checked only in ARP responses.
Description
Enter the ARP access list name used here. This name can be up to 32
characters long.
Enter the VLAN ID list used here.
Select whether to use a static ACL or not here by either selecting Yes
or No.
494