D-Link DXS-3600 Series Reference Manual page 418

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Destination
IP Precedence
ToS
DSCP
Time Range
Click the Apply button to accept the changes made.
Click the Back button to discard the changes made and return to the previous page.
To enable the Counter State option or to enter a Remark for the ACL, click the Edit button, next to the
specific ACL (found in the ACL table).
Figure 8-55 Extended IP ACL (Counter State Enabled) Window
The fields that can be configured are described below:
Parameter
Start Sequence No.
Description
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, IP, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IP address here. When the IP option is selected, the
Wildcard option will also be available. Enter the group of destination
IP addresses by using a wildcard bitmap. The bit corresponding to the
bit value 1 will be ignored. The bit corresponding to the bit value 0 will
be checked.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the time profile name that will be associated with this ACL rule,
here.
Description
Enter the start sequence number here.
407