D-Link DXS-3600 Series Reference Manual page 152

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Limit Number
Action
VID
Click the Apply button to accept the changes made.
The fields that can be configured in IGMP Snooping Limit Settings are described below:
Parameter
Unit
From Port ~ To Port
Limit Number
Exceed Action
Except ACL Name
VID
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
The fields that can be configured in Access Group Settings are described below:
Parameter
Unit
From Port ~ To Port
Action
Description
available if the Port option was selected as the action below.
Enter the limit number here. This is to configure the rate of IGMP
control packets that the switch can process on a specific interface. The
range is from 1 to 1000 packets per second. Select the No Limit
option to remove the limitation.
Select the action that will be taken here. Options to choose from are
Port and VLAN.
Enter the VLAN's ID here. This is the Layer 2 VLAN on a trunk port
and applies the filter to packets that arrive on that VLAN. The range is
from 1 to 4094. This is only available if the VLAN option was selected
as the action.
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Enter the limit number here. This is used to set the limitation on the
number of IGMP cache entries that can be created. The range is from
1 to 2048.
Select the exceed action here. This parameter specifies the action for
handling newly learned groups when the limitation is exceeded.
Options to choose from are Default, Drop and Replace.
•
Default: Specifies that the default action will be taken.
•
Drop: Specifies that the new group will be dropped.
•
Replace: Specifies that the new group will replace the oldest
group.
Enter the standard IP access list's name here. The group (*,G), or
channel (S,G) permitted by the access list will be excluded from the
limit. To permit a channel (S,G), specify S in the source address field
and G in the destination address field of the access list entry. To
permit a group (*,G), specify "any" in the source address field and G in
the destination address field of the access list entry. This name can be
up to 32 characters long.
Enter the Layer 2 VLAN's name on a trunk port here. This applies the
filter to packets that arrive on that VLAN. The range is from 1 to 4094.
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
141