D-Link DXS-3600 Series Reference Manual page 150

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Proxy Reporting
Source Address
Rate Limit
Ignore Topology Change
Click the Apply button to accept the changes made.
IGMP Snooping Groups Settings
This window is used to view and configure and view the IGMP snooping static group, and view IGMP
snooping group.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP
Snooping Groups Settings, as shown below:
The fields that can be configured in IGMP Snooping Static Groups Settings are described below:
Parameter
VID
Group Address
Unit
From Port ~ To Port
VID
Group Address
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Description
Select this option to enable or disable the proxy-reporting function.
Enter the source IP of proxy reporting. This is available when Enabled
is selected in Proxy Reporting.
Enter the rate limit value here. The range is from 1 to 1000. Tick the
No Limit option to apply no rate limit on this profile.
Select to enable or disable the ignore topology change feature here.
Figure 5-58 IGMP Snooping Groups Settings Window
Description
Enter a VLAN ID of the multicast group. The range is from 1 to 4094.
Enter an IP multicast group address.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Click the radio button and enter a VLAN ID of the multicast group. The
range is from 1 to 4094.
Click the radio button and enter an IP multicast group address.
139