Ddm Bias Current Threshold Settings; Ddm Tx Power Threshold Settings - D-Link DXS-3600 Series Reference Manual

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

Click the Apply button to accept the changes made.

DDM Bias Current Threshold Settings

This window is used to view and configure the threshold of the bias current for specific ports on the

To view the following window, click OAM > DDM > DDM Bias Current Threshold Settings, as shown

The fields that can be configured in DDM Bias Current Threshold Settings are described below:

Click the Apply button to accept the changes made.

This window is used to view and configure the threshold of TX power for specific ports on the Switch.

To view the following window, click OAM > DDM > DDM TX Power Threshold Settings, as shown below:

Add and Delete.

Select the type of voltage threshold. Options to choose from are Low

Alarm, Low Warning, High Alarm, and High Warning.

Enter the threshold value. This value must be between 0 and 6.55 Volt.

Figure 10-28 DDM Bias Current Threshold Settings Window

Select the switch unit that will be used for this configuration here.

Select the port used for the configuration here.

Select the action that will be taken here. Options to choose from are

Add and Delete.

Select the type of bias current threshold. Options to choose from are

Low Alarm, Low Warning, High Alarm, and High Warning.

Enter the threshold value. This value must be between 0 and 131 mA.