D-Link DXS-3600 Series Reference Manual page 677

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
is configured on the RADIUS server with a value of "0", the effective bandwidth will be set "no_limited",
and if the bandwidth is configured less than "0" or greater than maximum supported value, the bandwidth
will be ignored.
To assign the 802.1p Default Priority by the RADIUS server, the proper parameters should be
configured on the RADIUS server. The table below shows the parameters for 802.1p default priority.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the 802.1p priority attribute of the RADIUS server (for example, priority 7) and
the 802.1X, or MAC based authentication is successful, the device will assign the 802.1p default priority
(according to the RADIUS server) to the port. However, if the user does not configure the priority attribute
and authenticates successfully, the device will not assign a priority to this port. If the priority attribute is
configured on the RADIUS server is a value out of range (>7), it will not be set to the device.
To assign the VLAN by the RADIUS server, the proper parameters should be configured on the RADIUS
server. To use VLAN assignment, RFC 3580 defines the following tunnel attributes in RADIUS packets.
The table below shows the parameters for a VLAN:
RADIUS Tunnel Attribute
Tunnel-Type
Tunnel-Medium-Type
Tunnel-Private-Group-ID
A summary of the Tunnel-Private-Group-ID Attribute format is shown below.
0
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
The table below shows the definition of Tag field (different with RFC 2868):
Description
Defines the vendor.
Defines the attribute.
Used to assign the 802.1p
default priority of the port.
Description
This attribute indicates the
tunneling protocol(s) to be
used (in the case of a tunnel
initiator) or the tunneling
protocol in use (in the case
of a tunnel terminator).
This attribute indicates the
transport medium being
used.
This attribute indicates group
ID for a particular tunneled
session.
1 2
Length | Tag
666
Value
171 (DLINK)
4
0 to 7
Value
13 (VLAN)
6 (802)
A string (VID)
3
| String...
Usage
Required
Required
Required
Usage
Required
Required
Required