D-Link DXS-3600 Series Reference Manual page 160

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD

Snooping Filter Settings, as shown below:

The fields that can be configured in MLD Snooping Rate Limit Settings are described below:

From Port ~ To Port

Limit Number

Click the Apply button to accept the changes made.

The fields that can be configured in MLD Snooping Limit Settings are described below:

Figure 5-66 MLD Snooping Filter Settings Window

Select the switch's unit ID that will be used here.

Select the switch's port range that will be used here. This is only

available if the Port option was selected as the action below.

Enter the limit number here. This is to configure the rate of MLD

control packets that the switch can process on a specific interface. The

range is from 1 to 1000 packets per second. Select the No Limit

option to remove the limitation.

Select the action that will be taken here. Options to choose from are

Port and VLAN.

Enter the VLAN's ID here. This is the Layer 2 VLAN on a trunk port

and applies the filter to packets that arrive on that VLAN. The range is

from 1 to 4094. This is only available if the VLAN option was selected

as the action.

Select the switch unit that will be used for this configuration here.