D-Link DXS-3600 Series Reference Manual page 416

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
IP Precedence
ToS
DSCP
Time Range
After selecting the Protocol ID option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-53 Extended IP ACL (Add Rule) Protocol ID Window
The dynamic fields that can be configured are described below:
Parameter
Protocol
Fragments
Source
Destination
Description
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the time profile name that will be associated with this ACL rule,
here.
Description
Enter the Protocol ID value in the space provided. This value must be
between 0 and 255.
Select the Fragments option to include packet fragment filtering.
Select and enter the source information here. Options to choose from
are Any, Host, IP, and Wildcard. When the Any option is selected,
any source traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the source host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
405