Settings For Weighing; Settings For Printouts - Sartorius cubis MPS Quick Reference Manual

Task Management
Select the application for the task profile:
Task a New a Application 1
Weighing
Mass unit conversion
Individual identifiers
Density determination
Statistics
Back Done
Please check the weighing parameters in this
task:
Task a New a Weighing a Overview
Stable conditions
Adapt filter:
Application filter: Final readout
Stability: Exact center
Stability delay: Short delay
Zero/tare function: After stability
Back Wizard Done
Please check the printout parameters of
this task:
Task a New a Print a Overview
Com A; Com B
Printout interface:
Protocol (Com A): Print
Stand. printout (Com A) Standard 1
GLP printing (Com A): Off
Print event (Com A): PRINT
Back Wizard Done
Please select events (Com A) to trigger print-
outs:
... a New a Print a Overview aPrint event (Com A)
"PRINT" key
Start of task
End of task
Calibration/adjustment result
®
38 Cubis MPS Quick Reference Guide
y
An application list is displayed.
t
To view all applications, use the scroll bar on the right.
t
Select the application you want to assign to the new task.
t
Configure this application as required. The program guides you through the
configuration menu.
t
If you want to assign more additional applications to the task, these applications
should also be configured (see "Combining applications into one task").
y
Next
After all applications for the new task have been configured, the following two
parameters have to be set: Configure the settings for weighing and printouts.
All settings configured here will only affect the new task.
5.3.2

Settings for Weighing

t
Check the settings and change them as required.
To find explanations for each of the options, first touch
t
Touch .
Next
Next
5.3.3

Settings for Printouts

t
Check the settings and change them as required.
t
To find explanations for each of the options, first touch
To define which event should trigger a print job:
t
Touch .
PRINT
Next
t
Select the desired print events. The print events which can be selected depend
on the selected application.
You can start printing by pressing the
automatically at the
or when the calibration/adjustment result
t
Touch OK .
OK
"PRINT" key
start of the task , after the
and then
Wizard Info
Wizard and then Info
or trigger printing
end of the task ,
is displayed.
.
.