Connecting Power To Hdp5000 Printer And Lamination Module - HID HDP5000 User Manual

All rights reserved
Connecting Power to HDP5000 Printer and
Lamination Module
Caution: Do not plug in the USB cable until prompted to do so during the
installation of the HDP5000 Printer Driver. Refer to the Driver installation procedure below.
Step Procedure
1 The Printer and Lamination Module connections are shown in the Displays A
to C
2 Use the same procedure for both the Printer and the Lamination Module.
Power up the lamination module first then the printer.
Note: If no Lamination Module is used then plug in the printer first.
3 IMPORTANT NOTE: After the printer and lamination module is connected to
the power then the USB cable may be plugged into the computer. Do not
connect the USB before the printer has been powered up.
Display A - Connecting the AC power cable to the power supply.
.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8 55