Connecting The Printer Power - HID FargoDTC 1250e Setup Procedure

Photocard printer Setup
3. Load up to 100 cards into the hopper. (If using cards with a magnetic stripe*, the magnetic stripe
should be loaded with the stripe up and to the front of the Printer.)
* Please note that the DTC Fargo 1250e is NOT an encoding printer
4.
Close the input card hopper door to release the lever to the printing position.

Connecting the Printer Power

1. Plug the AC adapter power cable into the back of the printer.
2. Plug the wall power cable into the AC power adapter.
3. Plug the wall power cable into a standard 100-240VAC power outlet.
Note: Do not turn on the printer until prompted during the printer driver installation.
v.1.0
6