HID HDP5000 User Manual page 13

All rights reserved
Reviewing the HDP5000 Sequence of Operations
Step Process
22 The Film Drive and Stepper turn ON for a given number of clicks based on Film
Encoder, until the film is released.
23 The Stepper turns ON to move the card into Flipper Module to flip the card to
the opposite side. After flipping the card is transported back to the Card
Feed/Position Sensor to repeat Steps 9 to 14.
Upon completion of print all print cycles the card is transported to the Output
Hopper (based on steps from a known from Flipper Card Position Sensor). All
stop.
24 The Heater is maintained at a set temperature by the RTD when the Printer is
ON. The cooling fan is ON when the Printhead is ON or hot.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8 13